Volkswagen Jetta 2005 Workshop Manual page 313

– Secure door window against sliding down with adhesive tape.
– Remove the three bolts -2-.
– Disconnect connector -1-.
– Remove window regulator motor with control unit -3- from
mounting plate.
3.8.2 Installing
– Push window regulator motor -3- into place and reconnect
connector -1-.
– Move door window lightly up and down so that the splines be‐
tween motor and cable drum engage easier.
– Tighten bolts -2- window regulator motor.
Specified torque for bolts -2- 3.5 Nm
– Run window regulator twice in each direction to upper and
lower stops. This initiates and readies the window regulator
motor and activates the roll-back function.
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
3. Rear door window (saloon)
303