Removing And Installing Lock Carrier With Add-On Parts - Volkswagen Jetta 2005 Workshop Manual

Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
Note
Ensure that the charge air cooler pressure hoses are properly
♦
engaged again.
Hoses and lines must not be pinched.
♦
If necessary, replenish coolant ⇒ Rep. Gr. 19 ; Removing and
♦
installing parts of coolant system .
1.3.3 Releasing pressure hoses
– Release push-on coupling -1- and pull pressure hose -2- in
direction of -arrow- out of coupling.
During installation of pressure hoses, ensure that push-on cou‐
pling engages audibly.
1.4 Removing and installing lock carrier with
add-on parts
1.4.1 Removing
Note
Because the lock carrier is a safety-relevant component, it must not be repaired.
♦
If damaged, the lock carrier must be renewed.
♦
– Set lock carrier with add-on parts -1- to service position
⇒ page 2 .
– Disconnect all electrical connectors.
– Drain coolant and disconnect coolant hoses ⇒ Rep. Gr. 19 ;
Removing and installing parts of coolant system .
– Disconnect lines for condenser ⇒ Heating, air conditioning
system; Rep. Gr. 87 .
– Together with a second mechanic, unscrew guide pins -
T10093- from left and right longitudinal member and lift lock
carrier out -1-.
Caution
Do not start the engine if the air conditioning system and/or the
coolant system lines are disconnected.
4
Rep. Gr.50 - Body - front