– Install the boot with the selector knob and, if necessary, the
noise insulation. Refer to
⇒ 1.4 Gearshift Knob, Removing and Installingg , page 62
– Replace the clamp -arrow-.
– Install the heat shield under the shift lever mechanism. Refer
to ⇒ Body Exterior; Rep. Gr. 66 ; Molding/Trim/Extensions/
Trim Panels; Floor Heat Shield, Removing and Installing .
– Assemble the exhaust system free of tension. Refer to ⇒ En‐
gine Mechanical, Fuel Injection and Ignition; Rep. Gr. 26 ;
Exhaust Pipes/Mufflers; Overview - Muffler .
– Install the air filter housing.
Vehicles with a Turbo Diesel Engine
– Refer to ⇒ Engine Mechanical, Fuel Injection and Glow Plug;
Rep. Gr. 23 ; Air Filter; Air Filter Housing, Removing and In‐
stalling .
Vehicles with a Gasoline Engine
– Refer to ⇒ Engine Mechanical, Fuel Injection and Ignition;
Rep. Gr. 24 ; Air Filter; Air Filter Housing, Removing and In‐
stalling .
Continuation for All
– Install the battery tray, battery and the battery cover. Refer to
⇒ Electrical Equipment; Rep. Gr. 27 ; Battery; Battery, Dis‐
connecting and Connecting .
Tightening Specifications
♦ Refer to
⇒ 1.3 Overview - Shift Lever Knob and Cover , page 62
♦ Refer to
⇒ 1.2 Overview - Selector Mechanism , page 60
1.6
Selector Mechanism, Adjusting
Special tools and workshop equipment required
♦ Connecting Pin - T10027A-
Adjusting Requirements
•
Operating and transfer elements of shift mechanism must be
in proper condition.
•
Shift mechanism must move freely.
•
The transmission, clutch and clutch mechanism must also be
in proper condition.
•
Transmission in neutral.
– Remove the air filter housing if the bracket -A- for the selector
shaft and the securing mechanism for the shift and selector
cables are not accessible.
Vehicles with a Turbo Diesel Engine
– Refer to ⇒ Engine Mechanical, Fuel Injection and Glow Plug;
Rep. Gr. 23 ; Air Filter; Air Filter Housing, Removing and In‐
stalling .
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
.
.
1. Selector Mechanism
71