Volkswagen Jetta 2005 Workshop Manual page 305

3.3.1 Removing
Note
When door outer panel has been removed the spreader pin and
spreader plug to remove door window are accessible from exte‐
rior.
– Remove rear door trim ⇒ General body repairs, interior; Rep.
Gr. 70 ; Door trim .
– Lever out caps -5-.
– Lower door window until spreader pin -3- and spreader plug
-4- in cut-out of window regulator is accessible.
Note
If the work step cannot be carried out because there is a fault with
the electric window motor, remove motor to slide window down.
– Screw a 5 mm bolt (approx. 70 mm long) into spreader pin
-3-.
– Pull bolt and spreader pin out of spreader plug -4-.
– Screw an 8 mm bolt (approx. 80 mm long) into spreader plug
-4-.
Note
Do not exert too great a pressure on the plug because otherwise
the plug will fall into the door.
– Pull spreader plug -4- out of clamping jaws -2- and therefore
out of door window.
– Remove window regulator motor
– Lower door window fully.
– Pull window channel -3- out of mounting.
– Remove screws -2- and pull trim -1- towards B-pillar
-direction of arrow-.
General body repairs, exterior - Edition 10.2009
⇒ page 302 .
Golf Variant 2007 ➤ , Jetta 2005 ➤
3. Rear door window (saloon)
295