Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
– Pull out outer seal -1- in bonding area -3- from roof -2-.
– Cut off all round profile of outer seal -1- in -arrow- area, flush
with edge of roof -4-.
– Remaining part -3- stays between roof -4- and assembly frame
-2-.
– Remove existing adhesive residue using adhesive strip re‐
mover -VAS 6349- .
– Entire bonding surface on roof cut-out must be free of dust and
grease.
– Clean bonding surface completely using cleaning solution -D
009 401 04- .
Note
New seal is supplied in excess length. Cut new seal to appro‐
♦
priate length. It is recommended to leave new seal 1-2 mm
longer and to sprain any excess length.
To guarantee a good bonding of seal, do not bond at a tem‐
♦
perature below 20°C.
♦
After bonding outer seal, wait at least 30 min before fitting
glass panel to assure seal does not unstick.
192
Rep. Gr.60 - Sunroof