Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
– Finally carry out a functional check.
1.12
Adjusting drive for sliding/tilting sunroof
glass panel (0 position)
There may be a requirement to adjust the zero (0) position if the
drive was removed when not in the zero position or the sliding/
tilting sunroof glass panel was opened or closed using the emer‐
gency key.
•
Drive removed but still connected electrically.
– Select "open sunroof" using preselection control rotary switch.
– Select "close sunroof" using preselection control rotary switch.
– Select "tilt sunroof" using preselection control rotary switch.
– Select "close sunroof" using preselection control rotary switch.
– Install drive in this position (zero position) with sunroof closed.
The sliding/tilting sunroof glass panel drive is in zero (0) position,
if a white dot can be seen in the drive aperture -arrow-.
1.13
Removing and installing sliding/tilting
sunroof glass panel automatic preselec‐
tion switch
– Removing preselector for sliding/tilting sunroof roof glass pan‐
el ⇒ Electrical system; Rep. Gr. 96 ; Lights and switches in
roof trim .
1.14
Checking parallel running
– Removing glass panel for sunroof
172
Rep. Gr.60 - Sunroof
⇒ page 166
.