Renewing Seals For Rear Glass Panel - Volkswagen Jetta 2005 Workshop Manual

Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
– Pull inner seal -3- slightly backwards at -arrow- positions and
remove bolts -2- of rear glass panel -1-.
– Adjust rear glass panel -2- as shown in illustration.
♦ Dimension -a- = 1.5 ± 1 mm
♦ Dimension -b- = 1 ± 1 mm
♦ Dimension -c- = 1 ± 1 mm
– Tighten left and right bolts (5 Nm).
2.8

Renewing seals for rear glass panel

– Remove rear glass panel
Renew front and inner seals
– Pull respective seal -1- off rear glass panel.
♦ 2 Front seal
♦ 3 Inner seal
– Remove existing adhesive residue using adhesive strip re‐
mover -VAS 6349- .
– Bonding surface on glass panel must be free of dust and
grease.
– Clean bonding surface completely using cleaning solution -D
009 401 04- .
Note
To guarantee a good bonding of seal, do not bond at a tempera‐
ture below 20°C.
– Remove protective backing from adhesive tape of new seal
and press on seal at both ends.
– Sprain any seal excess length evenly.
– Press in seal evenly using roller for door insulation foil -3356- .
– Install rear glass panel
Removing side seal
190
Rep. Gr.60 - Sunroof
⇒ page 187 .
⇒ page 187 .