– Lift a corner of side member extension -1- using wedge
-3409- .
– Firmly holding corner, forcefully pull side member extension
-1- from side panel.
Note
Cut bonding using suitable equipment, if required.
5.3.3
Installing
– Installation instructions
– Preparing body component for bonding
– Preparing new add-on part for bonding
– Apply 2K glass adhesive -DA 004 600 A2- to sealing surfaces
-3- and -4- evenly along the complete length of the side mem‐
ber extension -1- using double cartridge gun -VAS 5237- .
– Apply 2K glass adhesive -DA 004 600 A2- to front and rear
spacers -5-.
⇒ page 353
.
⇒ page 352
⇒ page 353
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
349
5. Mouldings and trims