6
Special add-on parts
6.1
Safety requirements
Caution
When removing special add-on parts, use suitable gloves and
protective eyewear.
Special add-on parts must cure at least 3 hours after being
bonded before work on the vehicle is continued.
Note
The following special add-on parts have been developed to
♦
fulfil the technical requirements of the respective models.
These special add-on parts should always be replaced with
the corresponding genuine parts.
Without these special add-on parts, the vehicle will not comply
♦
with the traffic regulations.
6.2
Fitting notes for extensions
Note
The side member extension are applied with adhesive at the
♦
factory.
The side member extensions are supplied primed by the sup‐
♦
plier.
Ensure the side member extension adhesive surfaces remain
♦
free of paint and paint mist when painting extensions.
6.3
Materials
♦ 2K glass adhesive
♦ Static mixer with tapered noz‐
zle
♦ Primer
♦ Cleaning solution
♦ Primer applicator
♦ Adhesive remover
♦ Activator
Note
Observe instructions for use on the information sheet provided by
the manufacturer.
General body repairs, exterior - Edition 10.2009
-DA 004 600 A2-
-D 002 001-
-D 009 200 02-
-D 009 401 04-
-D 009 500 25-
-D 002 000 10-
-D 181 801 A1-
Golf Variant 2007 ➤ , Jetta 2005 ➤
6. Special add-on parts
351