Assembly Overview - Sliding/Tilting Sunroof With Glass Panel - Volkswagen Jetta 2005 Workshop Manual

1.3

Assembly overview - sliding/tilting sunroof with glass panel

1 - Glass panel for sliding/tilting
sunroof (single pane safety
glass)
❑ Removing and installing
⇒ page 166
❑ Adjusting ⇒ page 167
2 - Panel seal
❑ Renewing ⇒ page 169
❑ Adjusting ⇒ page 168
❑ Joint of seal centred at
rear
3 - Sliding headliner
❑ Removing and installing
⇒ page 170
4 - Bolt
❑ Bolts are microencap‐
sulated and must al‐
ways be renewed after
loosening.
❑ Qty. 4
❑ 1.8 Nm
5 - Spring slide
❑ Screwed to sliding
headliner
❑ Qty. 4
❑ Can be renewed individ‐
ually.
❑ Removing ⇒ page 170
6 - Bellows
❑ To cover guide plate.
❑ Removing and installing
⇒ page 164
7 - Water channel
❑ Removing ⇒ page 178
8 - Latch guide
❑ Is removed together with guide plate
9 - End piece upper part
❑ Clipped to end piece upper part.
❑ Removing ⇒ page 178
10 - End piece lower part
❑ Can be renewed individually.
❑ To seal use butyl adhesive sealing cord -AKL 450 005 05- .
11 - Carrier unit
❑ Removing and installing
❑ If needed, guide channels may be greased only with special grease -G 000 450 02- , otherwise correct
operation cannot be guaranteed.
12 - Bolt
❑ Bolts are microencapsulated and must always be renewed after loosening.
General body repairs, exterior - Edition 10.2009
⇒ page 178
⇒ page 174
Golf Variant 2007 ➤ , Jetta 2005 ➤
1. Sliding/tilting sunroof with glass panel (Meritor)
163