Removing And Installing Sliding/Tilting Sunroof Glass Panel Drive - Volkswagen Jetta 2005 Workshop Manual

1.10.2 Installing
Install in reverse order of removal.
Finally carry out a functional check.
1.11 Removing and installing sliding/tilting
sunroof glass panel drive
1.11.1 Removing
– Removing lights and front operating unit ⇒ Electrical system;
Rep. Gr. 96 ; Lights and switches in roof trim .
Motor change - preselction switch recognition:
Note
To interrupt the authorization signal and therefore to activate
♦
the switch recognition, the requirements described below must
be fulfilled.
If this is not the case, it can lead to, that the drive does not
♦
correctly recognise the preselection switch and does not run
to the selected positions. This can be seen if the sunroof stops
approx. 10 cm before the fully closed position when the switch
is in the closed position.
Caution
Remove or install drive for tilting/sliding sunroof glass panel
only when sunroof is closed (0 position ).
The requirements for removing and installing drive are: engine
not running and ignition off, key not in ignition and door open.
– Switch off engine and ignition, withdraw key and open door.
This condition must remain until drive has been installed.
– Remove screws -arrows- and pull off sliding/tilting sunroof
drive.
– Separate connector for sliding/tilting sunroof drive.
1.11.2 Installing
The screws for the sliding/tilting sunroof drive are microencapsu‐
lated and must always be renewed (3.5 Nm).
Install in reverse order of removal.
After installation is complete, key can be inserted into lock cylin‐
der of ignition/starter switch again.
Golf Variant 2007 ➤ , Jetta 2005 ➤
General body repairs, exterior - Edition 10.2009
1. Sliding/tilting sunroof with glass panel (Meritor)
171