Clock - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Overview
Software Overview
Some examples of clear commands include the following:
Syntax: clear ip policy-sessions
This command clears all sessions established using the ACPs applied to router
interfaces.
Syntax: clear ip route [** | <A.B.C.D>]
The ** option clears all routes learned through a routing protocol. Static
routes are not affected. You can clear a single route by entering the destination
IP address.

Clock

The clock command in the enable mode context allows you to set the clock,
adjust for the time zone, and manage the clock source. To view the options
for the clock command, enter:
Syntax: clock ?
For example, to set the clock and the time zone, enter:
Syntax: clock set <HH:MM:SS>
Syntax: clock timezone <zone>
Enter clock timezone ? for a complete list of keywords for the time zones of
various locations.
Daylight Savings Time Auto Correction. The router is set to automati-
cally correct the time for daylight savings time. If the router is operating in an
area that does not observe daylight savings time, you should disable this
option using the clock no-auto-correct-dst command. Enter:
ProCurve# clock no-auto-correct-dst
To re-enable daylight savings time correction, enter:
ProCurve# clock auto-correct-dst
1-45