HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 454

Configuring Demand Routing for Primary ISDN Modules
Viewing Information about Demand Routing
Demand 1 is UP (Spoofing)
Configuration:
Keep-alive is set (10 sec.)
Admin MTU = 1500
Mode: Either, 1 dial entries, idleTime = 120, fastIdle = 20
Resource pool Pool
No authentication configured
IP address 10.10.10.1 255.255.255.252
Recovery enabled, interval = 60, max-retries = 5
Connect Sequence:
Seq DialString
1 9634444
Current values:
Local IP address 10.10.10.1, Peer IP address 0.0.0.0
Queueing method: weighted fair
Output queue: 0/1/428/64/0 (size/highest/max total/threshold/drops)
Conversations
Available Bandwidth 48 kilobits/sec
Bandwidth=64 Kbps
8-62
Figure 8-16 shows the results of this command if demand interface 1 is
spoofing its up status and a dial-up connection has not been established. In
addition to showing the status of the interface, this command displays settings
for the following commands:
connect-mode
resource pool
connect-sequence
idle-timeout
fast-idle
ip address
Demand interface is spoofing its up status; a dial-up
connection is not actually established
Successes = 1, Failures = 0
Technology Successes Busys NoAnswers NoAuths InUse
IsdnForced
0/1/256 (active/max active/max total)
Figure 8-16. Viewing the Status of the Demand Interface When a Dial-Up
Connection Has Not Been Established
If a connection has been established through the demand interface, the show
interfaces demand 1 command shows:
the number of seconds until the ISDN connection is terminated
the number of frames in and out
the traffic that triggered the connection (the interesting traffic)
the amount of time the connection has been up
the BRI interface and channel through which the connection was
established
Resource pool
1 0 0
Information configured in the connect
sequence: dial-string (the number the
interface will call) and technology
connect-mode,
idle time, and
fast idle
0