Assign The Named List - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Controlling Management Access to the ProCurve Secure Router
Using the AAA Subsystem to Control Management Access
2-20

Assign the Named List

After you configure a named list, you must assign the list to the specific access
method. To assign a list to the console, Telnet, or SSH lines, move to the
appropriate line configuration mode context and enter:
Syntax: login authentication <named list>
For example, to assign ListA to the console line, enter:
ProCurve(config)# line console 0
ProCurve(config-con0)# login authentication ListA
To assign ListA to the Telnet 0 line, enter:
ProCurve(config)# line telnet 0
ProCurve(config-telnet0)# login authentication ListA
To assign ListA to all of the SSH lines, enter:
ProCurve(config)# line ssh 0 4
ProCurve(config-ssh0-4)# login authentication ListA
For FTP and HTTP access, you assign the list from the global configuration
mode context. If you want to assign a named list to control FTP access, enter:
Syntax: ftp authentication <named list>
If you want to assign a named list to control Web access, enter the following
command from the global configuration mode context:
Syntax: ip http authentication <named list>
No Named List Assigned. If you enable the AAA subsystem but do not
configure a named list and assign it to an access method (console, Telnet, FTP,
SSH, or HTTP), the ProCurve Secure Router handles authentication as outlined
in Table 2-3.