Quick Start - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

--------------------------------------------------------------------
t1 1/1 is UP
Receiver has no alarms
T1 coding is B8ZS, framing is ESF
Clock source is through t1 1/2, FDL type is ANSI
Line build-out is 0dB
No remote loopbacks, No network loopbacks
Acceptance of remote loopback requests enabled
Tx Alarm Enable: rai
Last clearing of counters never
loss of frame
loss of signal : 1, last occurred 00:10:41
AIS alarm
Remote alarm
DS0 Status: 123456789012345678901234
NNNNNNNNNNNNNNNNNNNNNNNN
Status Legend: '-' = DS0 is unallocated
'N' = DS0 is dedicated (nailed)
Line Status: -- No Alarms --
(OUTPUT TRUNCATED)--------------------------------------------------
Exit - 'Ctrl-C', Freeze - 'f', Resume - 'r'
Figure 4-13. Viewing the show interfaces Output in Real-Time
To end the output and return to troubleshooting the router, enter

Quick Start

This section provides the commands you must enter to quickly configure an
E1 or T1 interface on the ProCurve Secure Router. Only a minimal explanation
is provided.
If you need additional information about any of these options, see "Contents"
on page 4-1 to locate the section and page number that contains the explanation
you need.
: 1, last occurred 00:10:27
: 0
: 0
Configuring E1 and T1 Interfaces
Quick Start
40
Instructions
for pausing
or ending
the output
.
Ctrl+C
4-37