Configuring The Data Link Layer For The Adsl Connection; Creating The Atm Interface; Activating The Atm Interface - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

ADSL WAN Connections
ADSL Modules for the ProCurve Secure Router

Configuring the Data Link Layer for the ADSL Connection

You can configure the ADSL line with ATM as the Data Link Layer, or you can
configure ADSL with either PPPoE or PPPoA. No matter which option you
use, however, your configuration will include ATM, and you will need to
configure both an ATM interface and an ATM subinterface.

Creating the ATM Interface

To begin configuring ATM for an ADSL connection, you must create a logical
interface. From the global configuration mode context, enter:
Syntax: interface <interface> <number>
Replace <interface> with atm and replace <number> with any number
between 1 and 1024. Each ATM interface you configure on the router must
have a unique number.
For example, if you are configuring the first ATM interface on the router, you
might enter:
ProCurve(config)# interface atm 1
The router prompt indicates that you have entered the appropriate interface
configuration mode context:
ProCurve(config-atm 1)#
You can then enter the ? help command to display the commands available
from this configuration mode context.
ProCurve(config-atm 1)# ?

Activating the ATM Interface

By default, all logical interfaces on the ProCurve Secure Router are shutdown,
so you must activate the ATM interface. From the ATM interface configuration
mode context, enter:
ProCurve(config-atm 1)# no shutdown
7-17