Configuring Udp Relay - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Using the Web Browser Interface for Basic Configuration Tasks

Configuring UDP Relay

14-100
Configuring UDP Relay
You can configure the ProCurve Secure Router to forward packets destined
to certain UDP ports to a helper address. For example, your LAN may include
a DHCP server in only one of its VLANs. If your router will be routing between
the VLANs, it might receive DHCP discover requests from some clients. You
could configure the router to forward these requests to your network's DHCP
server.
Follow these steps to configure UDP relay:
1. Select UDP Relay from the lefthand navigation bar.
2. Move to the IP Helper Address window.
3. Enter the IP address of the server to which the router should forward
packets in the IP Helper Address fields.
4. From the Interface pull-down menu, select the interface on which the
router will receive the packets that need to be forwarded.
5. Click Add.
6. If necessary, configure the helper address for a different interface. Repeat
steps 3 through 5.
Figure 14-72. Configuring the Helper Address for UDP Relay
7. Move to the UDP Forward Protocol window.