Configuring The Idle-Timeout Option - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series
Hide thumbs Also See for ProCurve Secure 7000dl Series:
Table of Contents

Advertisement

Configuring Demand Routing for Primary ISDN Modules
Using Demand Routing for ISDN Connections
If the ProCurve Secure Router processes all of the connect sequences and
cannot establish a dial-up connection, the connect sequence attempt fails. For
the configuration shown in Figure 8-10, the ProCurve Secure Router will cycle
through the connect sequences three times. That is, it will attempt to call
5551212 (connect sequence 10) up to nine times in total and 5552222 (connect
sequence 20) up to three times in total.
If all three attempts are unsuccessful, the ProCurve Secure Router will change
the status of the demand interface to down (recovery active). Further, the
router will remove the demand interface's IP address and any routes referenc-
ing the interface (allowing any routes with higher administrative distances to
take their place).
In 60 seconds, the ProCurve Secure Router will try to process the connect
sequences again (although the demand interface will remain in recovery active
mode). That is, the router will call 5551212 once, 5552222 once, and then
5551212 twice again. If that attempt is unsuccessful, the ProCurve Secure
Router will try again in 60 seconds. Based on the configuration in Figure 8-10,
the ProCurve Secure Router will try up to five times or until a connection is
successful.
If all the connection attempts made during the recovery active mode are
unsuccessful, the ProCurve Secure Router will change the status of the
demand interface to down (recovery failed) until you take some action to
intervene. (See "Troubleshooting Demand Routing" on page 8-68.) If a connec-
tion is successful, the ProCurve Secure Router will change the status of the
demand interface to up (connected), activate the IP address for the interface,
and reinstate any routes to the interface.

Configuring the idle-timeout Option

You can configure the amount of time that the demand interface remains up
in the absence of interesting traffic. From the demand interface configuration
mode context, enter:
Syntax: idle-timeout <seconds>
Replace <seconds> with a number between 1 and 2147483. (The range is 1
second to more than 596 hours.)
The default setting is 120 seconds.
8-37

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 7102dl seriesProcurve 7103dl series

Table of Contents