Queuing Method - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Checking the Status of Logical Interfaces
6-54
ppp 1 is UP
Configuration:
Keep-alive is set (10 sec.)
No multilink
MTU = 1492
No authentication
IP is configured
192.168.1.20
Link thru atm 1.1 is UP; LCP state is OPENED, negotiated MTU is 1492
Receive: bytes=20296, pkts=2727, errors=0
Transmit: bytes=27728, pkts=2214, errors=0
5 minute input rate 208 bits/sec, 0 packets/sec
5 minute output rate 112 bits/sec, 0 packets/sec
Bundle information
Queueing method: fifo
HDLC tx ring limit: 0
Output queue: 0/1/200/0 (size/highest/max total/drops)
IP is UP, IPCP state is OPENED
Address=192.168.1.20 Mask=255.255.255.0
Peer address=192.168.1.1
IP MTU=1492, Bandwidth=896 Kbps
LLDPCP State is STOPPED
Figure 6-15. show interface ppp <number>
This command displays a report about the logical interface's status, including
information such as:
whether the interface is up or down
whether the physical link bound to the logical interface is up or down
whether the LCP is opened
endpoint settings
errors

queuing method

available bandwidth
the negotiated NCP and whether it is opened
IP address
peer IP address
Status of interface
No authentication is configured
255.255.255.0
IP address
Negotiated
MTU
Status of NCP
IP address of PPP peer