HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 721

You can configure the following router interfaces to receive a dynamic address
from a service provider or other DHCP server:
Ethernet interfaces
Frame Relay subinterfaces
ATM subinterfaces
bridged PPP interfaces
You can prevent the router from receiving a default route, DNS server address,
or domain name from the external DHCP server, but you must do so from the
CLI. See Chapter 13: Dynamic Host Configuration Protocol (DHCP).
These instructions assume that you have already created the logical interface
by selecting the encapsulation method for the physical interface. If you have
not done so, see "Configuring the Data Link Layer Protocol for E1, T1, and
Serial Interfaces" on page 14-46. Stop before you assign the logical interface
an IP address and return to this section.
Figure 14-71. Enabling the DHCP Client on an Interface
To configure the interface to receive a dynamic address, follow these steps:
1. In the left navigation bar, select IP Interfaces under Router/Bridge.
2. In the IP Interfaces window that appears, select the interface that you
want to take the dynamic address. The Configuration window for that
interface displays.
3. Scroll to the IP Settings section. Select DHCP from the Address Type pull-
down menu.
4. Click Apply.
Using the Web Browser Interface for Basic Configuration Tasks
Dynamic Host Configuration Protocol
14-99