HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 468

Configuring Demand Routing for Primary ISDN Modules
Quick Start
Setting
interface bri <slot>/<port>
isdn switch-type [basic-5ess | basic-ni |
basic-dms | basic-net3]
isdn ldn1 <number>
isdn ldn2 <number>
8-76
Table 8-17. debug Commands for PPP Interfaces
Command
debug ppp verbose
debug ppp errors
debug ppp negotiations
debug ppp authentication
undebug all
Quick Start
This section provides the commands you must enter to quickly configure
demand routing for:
an ISDN BRI U module
an ISDN BRI S/T module
Only a minimal explanation is provided. If you need additional information
about any of these options, check "Contents" on page 8-1 to locate the section
that contains the explanation you need.
When you configure demand routing, you will need to enter information about
your ISDN connection as well as information about the far-end network. You
can use Table 8-18 to record this information before you begin to configure
demand routing for the ISDN connection.
Table 8-18. Configuration Settings
Description
specifies the location of the ISDN module
and the port you are configuring
specifies the ISDN signaling that the
service provider implements on the line
specifies the telephone number (or
numbers) for ISDN BRI modules
Explanation
displays detailed information about all PPP frames as
they arrive on the PPP interface
displays error messages relating to PPP
displays events relating to link negotiation; shows if
link protocols are able to open; reveals when
negotiations between two PPP peers fail
displays real-time messages relating to PAP and CHAP
turns off debug messages
Your Setting