HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 373

Replace <number.subinterface number> with the unique number and
subinterface number that you assigned the ATM interface. For the ATM 1.1
subinterface, enter:
ProCurve# show interfaces atm 1.1
Figure 7-20 shows the output from this command for a sample network. As
you can see, this command displays the status of the interface and settings
such as the ATM encapsulation, the IP address, and the MTU size. The interface
shown in Figure 7-20 is configured to use RBE.
atm 1.1 is Active
ATM Routed Bridge Encapsulation: IP
Ip address is 192.168.1.20, mask is 255.255.255.0
MTU is 1500 bytes
Encapsulation is AAL5
Encapsulation method is SNAP
VC tx ring limit: 2
Output Queue: 0/1/200/0 (size/highest/max total/drops)
10007 packets input, 2881152 bytes
10066 packets output, 2886240 bytes
60024 cells input, 60130 cells output
0 OAM cells input, 0 OAM cells output
AAL5 CRC errors : 0
AAL5 SAR Timeouts : 0
AAL5 Oversized SDUs : 0
AAL5 length violations : 0
Figure 7-20. show interface atm Command for the Subinterface
To view the configuration settings entered for the ATM interface or subinter-
face, enter the appropriate command from the enable mode context:
Syntax: show running-config interface atm <number> [verbose]
or
Syntax: show running-config interface atm <number.subinterface number> [verbose]
To view all of the configuration settings for the ATM interface or subinterface,
include the verbose option at the end of these commands.
ADSL WAN Connections
Viewing the Status and Configuration of Interfaces
Interface is up
ATM encapsulation
Interface is
configured
for RBE
7-45