Events; Reload; Show - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Option
show access-lists [<name>]
show arp [interfaces <interface ID>] [realtime]
show atm pvc [interfaces atm <number.subinterface>] shows information about ATM PVCs on an ADSL connection
show atm traffic interface atm <number.subinterface> shows information about ATM traffic on a specific virtual
show autosynch-status
show backup interfaces
show bridge [<interface ID> | <bridge group>]
show buffers [users] [realtime]
show cflash
show clock [detail]

Events

The events command enables the Secure Router OS to display a notice to the
CLI whenever an event occurs. This command is useful for troubleshooting,
because it lets you immediately determine whether a connection is up and
working properly. This command is active in the default router settings. To
turn off the events reporting, enter no events.

Reload

This command exits the current session and reboots the router. Before exiting
the session, the Secure Router OS will ask whether you want to save the
running-config. It will also ask you to confirm that you want to reboot the
router.

Show

The enable mode context includes the complete set of show commands for
the Secure Router OS. Table 1-7 lists these show commands.
Table 1-7. Enable Mode Context show Commands
Result
displays ACLs, including all entries and the number of packets
the router has matched to each entry
shows the ARP table, which includes interfaces' IP and MAC
addresses
channel
reports whether the SROS.BIZ and startup-config in internal
flash and compact flash are synchronized
displays the backup configuration, including backup phone
numbers
displays the bridge table and, optionally, the table for a
particular logical interface or bridge group
lists the buffer pool statistics
lists files in compact flash
displays clock information such as the time, date, and time
source
Overview
Software Overview
1-51