HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 654

Using the Web Browser Interface for Basic Configuration Tasks
Configuring Ethernet Interfaces
14-32
5. Use the pull-down menu to configure the Speed/Duplex setting:
a. To select an automatically negotiated connection, select Auto.
b. To specify a 10 Mbps connection with half-or full-duplex, select
10Mbps/half or 10Mbps/full.
c. To specify a connection at 100 Mbps using a half- or full-duplex
setting, select 100Mbps/half or 100Mbps/full.
6. The factory-set MAC Address for the Ethernet interface is displayed
beneath the Speed/Duplex box. If you want to keep the MAC address of
the router's interfaces uniform, you can enable MAC Address Masquerade
by clicking the box. Then, enter the desired MAC address, in hexadecimal,
in the boxes provided.
7. Configure supplicant information if the Ethernet interface connects to a
network that requires 802.1X authentication.
a. Click the Supplicant box. Supplicant Username and Supplicant
Password boxes are displayed.
b. In these boxes, enter the username and password required to allow
the router to access the 802.1X network. (For more information about
the router functioning as an 802.1X client, see "Port Authentication"
on page 2-40.)
8. The Interface Mode pull-down allows you to choose IP routing or PPP
over Ethernet (PPPoE). The default setting is IP Routing. If you select
PPPoE and then click Apply, the PPPoE Configuration window is dis-
played. If you want to configure PPPoE for this interface, see "Configuring
PPPoE for the Ethernet Interface" on page 14-35.
9. Click Apply to save the changes you have made to the startup-config.
IP Settings
The IP Settings section allows you to configure the IP address and dynamic
Domain Name System (DNS) settings for the Ethernet interface.