Configuring Pppoe Or Pppoa For The Adsl Connection - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Using the Web Browser Interface for Basic Configuration Tasks

Configuring ADSL Interfaces

Status Information

You can view information about both the ATM interface and subinterface. To

view information about the ATM interface, move to the Configuration for

"atm <interface>" window and scroll to the bottom of the window. Likewise,

you can view the status of the ATM subinterface by scrolling to the bottom of

the Configuration for "atm <subinterface>" window.

Configuring PPPoE or PPPoA for the ADSL Connection

After you select PPPoE Client or PPP as the Interface Mode for the ATM

subinterface, a PPP configuration screen is displayed. (See Figure 14-52.) You

must then configure the PPP interface:

Enter a description if you need to document information about the PPP

interface. This information will be displayed in the running-config under

the appropriate PPP interface heading.

Click the Enabled box to activate the PPP interface.

For most environments, you can accept the default setting of 1500 for the

MTU. If you selected the PPPoE Client setting for the ATM Interface Mode,

the ProCurve Secure Router OS will automatically negotiate an MTU of

1492 with the PPP peer. If the two peers fail to negotiate an MTU of 1492,

you may need to set the MTU manually.

Select Default Peer Address if you want to configure the IP address of the

If you want to configure PPP authentication, see "PPP Authentication" on

Table of Contents