Connecting Simple Remote Sites - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

IP Routing—Configuring Static Routes
Quick Start
11-30
Quick Start
This section provides the commands you must enter to quickly configure static
routes.
Only a minimal explanation is provided. If you need additional information
about any of these options, check "Contents" on page 11-1 to locate the section
that contains the explanation you need.
Static Routing
Static routing may be good solution for your WAN if:
you are connecting remote sites that each only have one router
the router only needs to route traffic to an ISP
only one path is available to forward IP traffic

Connecting Simple Remote Sites

1. Configure a route to the remote network using the remote router's WAN
IP address as the next-hop address:
Syntax: ip route <destination network A.B.C.D> <subnet mask | /prefix length>
<next hop A.B.C.D | forwarding interface ID>
For example:
ProCurve(config)# ip route 192.168.3.0 /24 10.2.2.1
You can alternatively specify the connecting WAN interface on the local
router as the forwarding interface:
ProCurve(config)# ip route 192.168.3.0 /24 ppp 1
For Frame Relay connections, use the Frame Relay subinterface for the
PVC you want to use as the forwarding interface.
It can be a good idea to use the logical interface as the reference for the
route because IP addresses could change.
2. If necessary, add a route to another remote network.