Quick Start; Ppp - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces

Quick Start

To disable the hdlc debug messages, enter one of the following commands

from the enable mode context:

ProCurve# no debug hdlc [errors | verbose]

ProCurve# undebug all

After you configure the physical connection—the E1, T1, or serial interface—

you must configure the Data Link Layer protocol that controls the data being

transmitted across the WAN link. The ProCurve Secure Router supports the

following Data Link Layer protocols for E1, T1, and serial interfaces:

Point-to-Point Protocol (PPP)

High-Level Data Link Control (HDLC)

This section provides the commands you must enter to quickly configure the

Data Link Layer protocol for an E1, T1, or serial interface. Only a minimal

explanation is provided.

If you need additional information about any of these options, see "Contents"

on page 6-1 to locate the section and page number that contains the explana-

tion you need. (For information about E1 or T1 interface, see Chapter 4:

Configuring E1 and T1 Interfaces. For information about serial interfaces,

see Chapter 5: Configuring Serial Interfaces for E1- and T1-Carrier Lines.)

To configure PPP for an E1, T1, or serial interface, complete these steps:

From the global configuration mode context, create a PPP interface.

Syntax: interface <interface> <number>

For example, you might enter:

ProCurve(config)# interface ppp 1

Table of Contents