Terminal; Wall; Enable Mode Commands - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Overview
Software Overview
Similar to the ping command, you can set extended options for tracing a route
by entering traceroute and pressing without specifying the destination
Enter
address. Options include the source address at which the trace begins and the
maximum number of hops.
The traceroute command is also available from the enable mode context.

Terminal

Set the maximum number of lines to display on the screen during a terminal
session.
Syntax: terminal length <0-480>
If a readout includes more lines than the configured terminal length amount,
the display stops at the length limit and displays --MORE-- at the bottom.
To continue the display after the --MORE--, press Spacebar . To only display the
next line of the readout, press Enter . To return to the router prompt and end
the display, press a key.

Wall

Broadcast a message through the console port.
Syntax: wall <message>

Enable Mode Commands

To enter the enable mode context, enter enable from the basic mode context.
The following sections briefly describe some of the enable mode commands
and their functions.
I m p o r t a n t !
ProCurve strongly recommends that you set an enable password to prevent
unauthorized access to the router. If the enable mode context is not password
protected, anyone with console access to the router will be able to change the
configurations and compromise network security. See "Restricting Access to
the Enable Mode Context" on page 2-4 for more information on how to
configure an enable mode password.
1-43