HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 149

TAC+ TX: Sending Authentication START pkt
TAC+ TX: version=0xc0, type=Authentication, seq_no=1, flags=00
TAC+ TX: action=Login
TAC+ TX: level=1
TAC+ TX: authen type=ASCII
TAC+ TX: requested service=Login
TAC+ TX: username=
TAC+ TX: port=TELNET 0 (192.168.7.23:1072)
TAC+ TX: remote address=192.168.7.23
TAC+ RX: Received Authen REPLY pkt
TAC+ RX: version=0xc0, type=Authentication, seq_no=2, flags=00
TAC+ RX: status=GETUSER
TAC+ RX: flags=00
TAC+ RX: server msg=Login:
TAC+ TX: Sending Authentication CONTINUE pkt
TAC+ TX: version=0xc0, type=Authentication, seq_no=3, flags=00
TAC+ TX: user message=********
TAC+ TX: flags=0x00
TAC+ RX: Received Authen REPLY pkt
TAC+ RX: version=0xc0, type=Authentication, seq_no=4, flags=00
TAC+ RX: status=GETPASS
TAC+ RX: flags=0x01
TAC+ RX: server msg=Password:
TAC+ TX: Sending Authentication CONTINUE pkt
TAC+ TX: version=0xc0, type=Authentication, seq_no=5, flags=00
TAC+ TX: user message=********
TAC+ TX: flags=0x00
TAC+ RX: Received Authen REPLY pkt
TAC+ RX: version=0xc0, type=Authentication, seq_no=6, flags=00
TAC+ RX: status=PASS
TAC+ RX: flags=00
TAC+ RX: server msg=
Figure 2-7. Using Debug to Monitor Authentication Through the TACACS+ Server
Controlling Management Access to the ProCurve Secure Router
User is authenticated
Troubleshooting AAA
IP address of the
device trying to
establish a
Telnet session
2-39