Assigning An Ip Address; Viewing The Status Of Ethernet Interfaces Or Subinterfaces; Show Interfaces Command - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Assigning an IP Address

You must assign the Ethernet subinterfaces a static IP address. From the

Ethernet subinterface configuration mode context, enter:

Syntax: ip address <A.B.C.D> <subnet mask | /<prefix length>

For example, if you are configuring a subinterface for VLAN 2 and VLAN 2

encompasses the subnet 192.168.115.0 255.255.255.0, you might enter:

ProCurve(config-eth 0/1.1)# ip address 192.168.115.5 /24

Viewing the Status of Ethernet Interfaces

or Subinterfaces

After you configure an Ethernet interface or subinterface, you may want to

view the configuration settings you have entered, or you may want to deter-

mine the status of the interface—is the interface up, down, or administratively

down? You can use the following commands to view the configuration and

status of Ethernet interfaces and subinterfaces:

show running-config commands

show interfaces Command

To view the status of an Ethernet interface, move to the enable mode context

Syntax: show interfaces ethernet 0/<port>

For example, to view the status of the Ethernet 0/1 interface, enter:

ProCurve# show interfaces ethernet 0/1

If you are not at the enable mode context, you can use the do command. Enter:

ProCurve(config-eth 0/1)# do show interfaces ethernet 0/1

Configuring Ethernet Interfaces

Table of Contents