Isdn Modules - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

ISDN Modules

The two-port ISDN modules provide basic rate interface (BRI) ISDN for a
primary WAN connection. Each ISDN line can provide up to two 64 Kbps
channels. You can aggregate multiple channels for a single ISDN connection.
(However, you must configure the aggregation from the CLI.)
The ISDN BRI S/T module provides an interface to connect the router to
Network Termination 2 (NT2) or NT1 equipment. This module is used in areas
outside of North America.
The ISDN BRI U module provides an interface to connect the router to a
Network Interface Unit (NIU), or smart jack. This module is used in North
America.
Complete these steps to configure the physical interfaces on the ISDN module:
1. In the left navigation bar of the Web browser interface, select Physical
Interfaces. The interfaces for all of the modules installed in the router are
listed on the Physical Interfaces window.
2. The ports on the ISDN module are listed as BRI interfaces. Select the BRI
interface that you want to configure. The Configuration for the BRI
<slot>/<port> window is displayed.
Using the Web Browser Interface for Basic Configuration Tasks
ISDN Modules
14-71