Configuring Pppoe For The Ethernet Interface - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Figure 14-25.Status for Ethernet Interface

Configuring PPPoE for the Ethernet Interface

To configure PPPoE, complete the following steps:

Access the Configuration for Ethernet window, select PPPoE for the

Interface Mode, and click Apply. The PPPoE Configuration for "ppp

<interface number>" window displays.

Enter a description if you need to document information about PPPoE

settings. This information will be displayed in the running-config under

the appropriate PPP interface heading.

Click the Enabled box to activate the PPP interface.

For most environments, accept the default setting of 1500 for the MTU.

The ProCurve Secure Router OS will negotiate an MTU of 1492 with the

PPP peer. If the two peers fail to negotiate an MTU of 1492, you may need

to set the MTU manually.

Select Default Peer Address if you want to configure the IP address of the

Using the Web Browser Interface for Basic Configuration Tasks

Configuring Ethernet Interfaces

Table of Contents

Do you have a question about the ProCurve Secure 7000dl Series and is the answer not in the manual?