Configuring Ethernet Interfaces - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Configuring Ethernet Interfaces

To configure an Ethernet interface from the Web browser interface, complete

the following steps. If you need more information about any of the options,

see Chapter 3: Configuring Ethernet Interfaces.

Click Physical Interfaces in the left navigation bar.

Select the Ethernet port you want to configure (eth 0/1 or eth 0/2). The

Configuration for Ethernet window is displayed.

Figure 14-23. Configuration for Ethernet Window

If you want to document information about this Ethernet interface, enter

an alphanumeric string up to 80 characters in the Description box.

Click the Enable box and then click Apply at the bottom of the window

to activate the Ethernet interface immediately. You can also complete the

Ethernet configuration before clicking Apply.

Using the Web Browser Interface for Basic Configuration Tasks

Configuring Ethernet Interfaces

Table of Contents