Configuring A Serial Interface For An E1- Or T1-Carrier Line - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Using the Web Browser Interface for Basic Configuration Tasks

Configuring a Serial Interface for an E1- or T1-Carrier Line

Configuring a Serial Interface for an

E1- or T1-Carrier Line

If your public carrier provided you with an external CSU/DSU, you purchased

a serial module for the ProCurve Secure Router. When you set up an E1- or

T1-carrier line, you must configure the Physical Layer and the Data Link Layer.

This section explains how to configure the Physical Layer—the serial inter-

face. If you need additional information about any of the options, see Chapter

4: Configuring E1 and T1 Interfaces.

In the left navigation bar of the Web browser interface, select Physical

Interfaces. The interfaces for all of the modules installed in the router are

listed on the Physical Interfaces window.

Select the serial interface that you want to configure. The Configuration

for Serial <port number>/<slot number> window is displayed.

Figure 14-32. Configuration for Serial Window

Table of Contents