N o t e
12. View the status of the E1 or T1 interface.
ProCurve(config-e1 1/1)# do show interface e1 1/1
or
ProCurve(config-t1 1/1)# do show interface t1 1/1
The do command enables you to enter enable mode commands (such as show
commands) from any context.
By default, the ProCurve Secure Router immediately notifies you that the
interface is administratively up. It will take a few moments to establish the E1
or T1 connection, however. When the connection goes up, the ProCurve
Secure Router displays another message at the command line interface (CLI),
reporting that the line is up. If you want to disable this reporting function,
enter no events from the enable mode context.
You must now configure the Data Link Layer protocol for the E1 or T1
interface. For information about configuring this protocol, see Chapter 6:
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces.
Configuring E1 and T1 Interfaces
Quick Start
4-41