HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 698

Using the Web Browser Interface for Basic Configuration Tasks
E1 + G.703 and T1 + DSX-1 Modules
N o t e
14-76
4. To activate the interface, select the Enable box.
5. Ignore the clock source because you set the clock source for this module
on the E1 or T1 interface.
6. Set the frame format:
• If you are configuring a G.703 interface, use the pull-down menu to
select E1 or CRC4. E1 is the default setting.
• If you are configuring a DSX-1 interface, click ESF or D4. ESF is the
default setting.
7. Select the TS16 box to enable TS16 signaling if you are configuring a
G.703 interface. For more information about this setting, see Chapter 9:
Configuring the E1 + G.703 and T1 + DSX-1 Modules.
By default, the signaling-mode setting for the DSX-1 interface is set to
robbed-bit. If you need to change this setting, you must enter the command
from the CLI. You must also adjust the line-length setting from the CLI. For
information about these settings, see Chapter 9: Configuring the E1 + G.703
and T1 + DSX-1 Modules.
8. Use the pull-down menu to configure the coding:
• If you are configuring a G.703 interface, use the pull-down menu to
select HDB3 or AMI. HDB3 is the default setting.
• If you are configuring a DSX-1 interface, use the pull-down menu to
select B8ZS or AMI. B8ZS is the default setting.
9. Ignore the Data DS0s field because you configure channels for the E1 or
T1 interface and the remaining channels are assigned to the G.703 or
DSX-1 interface.
10. Click Apply to save your configurations.
Status Information
Status information is displayed at the bottom of the configuration for the G.703
or DSX-1 window. This readout is not in real-time. To update the readout to
the current statistics, click the Continuous Refresh button. To end continuous
refresh, click the Stop Updates button. To reset the statistics, click the Clear
Statistics button.