Quick Start; Configuring The Ethernet Interface - HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

Configuring Ethernet Interfaces

Quick Start

2005.08.27 15:31:53 ETHERNET_INTERFACE.eth 0/1 auto-negotiation in progress

2005.08.27 15:31:55 ETHERNET_INTERFACE.eth 0/1 auto-negotiation complete

2005.08.27 15:31:56 ETHERNET_INTERFACE.eth 0/1 link up

2005.08.27 15:31:56 ETHERNET_INTERFACE.eth 0/1 speed is 100Mbps, full duplex

2005.08.27 15:31:56 INTERFACE_STATUS.eth 0/1 changed state to up

Figure 3-9. debug interface ethernet Messages

To end the display of debug messages, enter:

Syntax: no debug interface <interface>

ProCurve# no debug interface ethernet

This section provides the commands you must enter to quickly configure

Ethernet interfaces. Only a minimal explanation is provided.

If you need additional information about any of these options, see "Contents"

on page 3-1 to locate the section and page number that contains the explanation

To configure the Ethernet interface, complete these steps:

Use a 10Base-T or 100Base-T cable to connect the Ethernet port on the

ProCurve Secure Router to the appropriate device on your LAN. In most

cases, you will connect the router to a switch.

Establish a terminal session with the ProCurve Secure Router. You are

automatically at the basic mode context.

Move to the enable mode context. If you have configured a password for

the enable mode context, enter that password when you are prompted to

ProCurve> enable

Table of Contents