HP ProCurve Secure 7000dl Series Basic Management And Configuration Manual page 366

Secure router procurve 7000dl series

Hide thumbs Also See for ProCurve Secure 7000dl Series:

Table of Contents

ADSL WAN Connections

PPPoA Overview

If you need to configure authentication protocols for the connection, see "PPP

Authentication" on page 6-71 in Chapter 6: Configuring the Data Link Layer

Protocol for E1, T1, and Serial Interfaces.

Binding the ATM Subinterface to the PPP Interface

To finish defining the point-to-point layer for the ADSL connection, you must

bind the ATM subinterface to the PPP interface. Enter the following command

from either the global configuration mode context or the PPP interface

configuration mode context:

Syntax: bind <bind number> atm <number.subinterface number> ppp <number>

Replace <bind number> with a bind number that you have not yet used on

the ProCurve Secure Router. Enter the interface numbers for the ATM sub-

interface and PPP interface that you want to bind together.

You can enter the show running-config command from the enable mode

context to ensure that you have entered the two bind commands that are

required for an ADSL connection that uses PPPoA. Figure 7-13 shows a section

of the running-config relating to an ADSL interface, ATM interface, ATM

subinterface, and PPP interface.

interface adsl 2/1

snr-margin 5

interface atm 1 point-to-point

bind 1 adsl 2/1 atm 1

interface atm 1.1 point-to-point

interface ppp 1

bind 2 atm 1.1 ppp 1

Figure 7-13. Using the show running-config Command to Check the Two bind

Commands Required for PPPoA

Bind the ADSL interface to the ATM interface

255.255.255.252

Bind the ATM subinterface to

the PPP interface

Chapters

Table of Contents