Chapter 10
Possible Cause
You have a graphics and per-
mit-only printing system.
Troubleshooting: Touchscreen Response
Description: Touchscreen is not responding to touch commands, or is not responding at all.
Possible Cause
The touchscreen needs to be cal-
ibrated.
Cable for touch capability may not
be attached properly to the touch-
screen (wiggled out of place).
If you have upgraded to the 15 inch
display, but did not swap out the
power cables, the touchscreen will
shut down approximately 30 min-
utes after power up.
Error Messages
You can look up error message definitions and resolutions on the Connect+ Customer Com-
munication Series support page.
1. Select the Error Message Lookup field.
2. If necessary, select the keyboard button to view the onscreen keyboard.
3. Enter the numeric code for the error message.
222
Solution
Graphics and permit-only printing sys-
tems do not print postage. Postage
refills are not required on these sys-
tems.
Solution
Calibrate the touchscreen.
Ensure the cable is properly
attached to the touchscreen.
Ensure appropriate power supply
cable is being used.
SV62250 Rev. G