Possible Cause
System is not filling with E-Z Seal®
Sealing Solution (Connect+® 3000
systems only.)
Description: Leading edge (first half) of envelope is not sealing; trailing edge envelope (sec-
ond half) is getting wet.
SV62250 Rev. G
Connect+® Series Operator Guide
Solution
1. Check that there is enough E-Z
Seal® sealing solution in the
envelope sealant bottle. Refill if
necessary.
2. Re-install the envelope sealant
bottle. Hold the bottle up
straight as you re-install.
3. Remove or lift the moistener
pad assembly to see if trough
has filled with sealant.
4. If the trough does not feel with
sealant, remove the wick. Let
the trough fill and reinstall the
wick.
If this becomes a regular occur-
rence, replace the wick.
217