Changing The Sealing Method - Pitney Bowes Connect+ 1000 Operator's Manual

Chapter 3
TIP: Weigh the lightest piece of mail in the stack and set a threshold below that value.
To edit the Differential weighing threshold:
1. Ensure that the appropriate job is open and selected on the Run Mail screen.
2. Select the Weighing icon.
3. Select Differential weighing.
4. Select Edit threshold.
5. Enter the appropriate threshold.
6. Select OK. The system returns you to the weighing method dialog box.
7. Select OK to return to the Run Mail screen.

Changing the Sealing Method

You can change the sealing method for a job while running mail. You can turn the sealer on
and off or seal envelopes without printing postage.
1. Ensure that the appropriate job is open and selected on the Run Mail screen.
2. Select the Sealer icon.
3. Select the appropriate sealing option.
Select Sealer on to print postal and/or non-postal elements and seal the envelope.
l
Select Sealer off to print postal and/or non-postal elements without sealing the envel-
l
ope.
Select Sealing only, no Printingto seal the envelope without printing.
l
4. If you selected "Sealer on" or "Sealing only, No printing" you can adjust the wetness of
the sealer for this job. Select and drag the control button to adjust the wetness. 1 is the dri-
est setting; 9 is the wettest. Use the + and - buttons for a more precise selection.
NOTE: This adjustment only changes the wetness setting for the selected job. If you do
not adjust the wetness, the job will use the default sealer wetness setting.
5. If you are using a Connect+® 3000, and you selected "Sealer on" or "Sealing only, No
printing", select the appropriate flap position:
65
SV62250 Rev. G