Creating A Combined Barcode Label Job - Pitney Bowes Connect+ 1000 Operator's Manual

Creating a Combined Barcode Label Job

The combined barcode label was created specifically for Electronic Return Receipt (ERR)
customers. You should create a job if you want to use these labels.
In order to use ERR, you should have a Bulk Proof of Delivery - Form 5053 on file with
l
the USPS and been given a 9-digit USPS Mailer ID. You will need to enter this number
when using ERR. If not, please contact your sales representative.
ERR is available when you use the Attached Scale or Manual Weight entry modes.
l
IMPORTANT: Turn off all tracking services prompts, except for Print Receipt, before cre-
ating and running mail with a combined barcode label job. If necessary, the prompts can be
turned on again later.
Follow the steps below to create a job that will allow you to scan the combined barcode
label. Setting up the job in this manner will ensure you can process mail as quickly as pos-
sible.
1. Place a piece of mail or package on the scale.
2. Select Class from the Job Properties list on the left side of the screen.
3. Select the class from the Class services list box, for example, First Class.
4. Select the mail piece type, for example, Letter.
5. Select the Electronic Certified special service from the Extra services list on the right. As
soon as you select the service, a check mark appears in front of it
6. You are prompted to enter a ZIP Code. Scan the combined barcode label and select OK.
7. Scan the next tracking label to be used.
If you have used all of the labels in a series of tracking number labels, make sure you
l
start with the top label with the lowest last 4-digits and not the bottom label with the
highest last 4-digits.
8. Select Electronic Return Receipt from the Extra services list.
9. Select OK.
10. Scan the combined barcode label. The Customer Reference Number will appear in the
Job Properties list box on the left side of the screen.
SV62250 Rev. G
Connect+® Series Operator Guide
94