Running A Manual Weight Entry Job; Running An Attached Scale Job - Pitney Bowes Connect+ 1000 Operator's Manual

Running a Manual Weight Entry Job

When you need to use a scale that is not connected to your system, you can still use the sys-
tem to calculate the postage for you.
1. Select the Run Mail button from the Home screen.
2. Select a job that uses Manual weight entry.
3. Place the mail piece on the detached scale and note its weight.
4. Select the Weighing icon.
a. Ensure the Manual weight entry option is selected.
b. If necessary, change the weighing units.
c. Enter the mail piece weight.
d. Select OK to go back to the Run Mail screen.
5. Select the class of service.
6. Put the mail on the feed deck.
7. Select Start, or if printing to tape, select Tape.

Running an Attached Scale Job

If you have a large mail piece that cannot be fed through your machine and you have an
attached scale, use the Attached Scale method. Note that the system will automatically
select this method if you place a piece of mail on your attached scale. It will also display the
weight of the mail piece next to the Weighing icon on the Run Mail screen. If the scale is not
set to zero when there is no weight on the scale you can reset it to zero.
1. Select the Run Mail button from the Home screen.
2. Select a job that uses an attached scale or select the Weighing icon.
a. Select the Attached scale option.
b. Make sure the scale reads 0 when there are no mail pieces or any objects on the
scale. If necessary, select Zero Scale.
c. Select OK.
SV62250 Rev. G
Connect+® Series Operator Guide
60