Cleaning Or Replacing The Moistener Wick - Pitney Bowes Connect+ 1000 Operator's Manual

Chapter 9
1. Select the Settings button on the Home screen.
2. The Settings screen displays. Select Hardware.
3. Select Sealer.
4. Select the Sealer settings tab.
5. Select and drag the control button to adjust the wetness. 1 is the driest setting; 9 is the
wettest. Use the + and - buttons for a more precise selection.
6. Select Run test envelope to test your adjustment.
7. Place an envelope on the feed deck and select Start. The system will feed and seal the
envelope.
8. Check the envelope to ensure the moistness adjustment is correct.
9. Select Done to return to the Home screen.

Cleaning or Replacing the Moistener Wick

If the seal quality does not improve after cleaning the moistener pad assembly, you can
replace the wick as needed.
Connect+® 1000 and Connect+® 2000 Systems
1. Open the supplies cover and lift out the envelope sealant bottle.The bottle is located to
the left of the tape roll.
2. Lift the feed cover.
3. Push down on the moistener pad assembly button.
4. Grasp the moistener pad assembly and pull it straight out towards you.
5. Use two fingers to remove the wick.
6. Clean the wick by holding it under running water.
7. Slide the wick back into place. Gently press down on the wick to ensure it is seated prop-
erly.
8. Push the moistener pad assembly back on its track until it snaps into position.
187
SV62250 Rev. G