Pitney Bowes Connect+ 1000 Operator's Manual page 24

Avoid touching moving parts or materials while the machine is in use. Keep hands, loose
l
clothing, jewelry and long hair away from all moving parts.
Do not remove covers or defeat safety interlock switches. Covers enclose hazardous
l
parts that should only be accessed by properly trained service personnel. Immediately
report to Pitney Bowes Service any damaged or non-functioning components that
renders the unit unsafe.
Place the unit in an accessible location to allow for proper venting of the equipment and
l
to facilitate servicing.
The power cord wall plug is the primary means of disconnecting the machine from the AC
l
supply.
Do not use an adapter plug on the line cord or wall outlet.
l
Do not remove the ground pin from the line cord.
l
Avoid using wall outlets that are controlled by wall switches, or shared with other equip-
l
ment.
Do not route the power cord over sharp edges or trapped between furniture.
l
Insure there is no strain on the power cord where it becomes jammed between the equip-
l
ment, walls or furniture.
Do not plug headphones into the Line Out jack
l
Be certain the area in front of the wall receptacle into which the machine is plugged is
l
free from obstruction.
Before clearing a stoppage, be sure machine mechanisms come to a stop.
l
When clearing a stoppage, avoid using too much force to protect against minor personal
l
injury and damaging equipment.
To prevent overheating, do not cover the vent openings.
l
Operation of this equipment without periodic maintenance will inhibit optimum operating
l
performance and could cause the equipment to malfunction. Contact your Pitney Bowes
Customer Service Representative for required service schedule.
Read all instructions before attempting to operate the equipment.
l
Use this equipment only for its intended purpose.
l
SV62250 Rev. G
Connect+® Series Operator Guide
(Lime Green).
20