Changing Or Selecting The Envelope Characteristics; Changing The Envelope Print Area - Pitney Bowes Connect+ 1000 Operator's Manual

Chapter 3
6. To adjust the horizontal or vertical alignment of the message or return address, select the
Text Block tab and select the appropriate alignment options.
7. To remove the message/return address from the envelope, deselect it.
NOTE: if you deselect a message, in order for the message to reappear in the list, you
must select the color filter button that corresponds to the color of the message. For exam-
ple, if you created the message in postal red, select the postal red filter button to redis-
play all of the messages done in postal red.

Changing or Selecting the Envelope Characteristics

Changing the Print Area
Changing the Color Print Quality
Changing Envelope Size

Changing the Envelope Print Area

You can change the top vertical and right horizontal edges of the printable area on the envel-
ope. By adjusting the top vertical edge, you move all of the elements (indicia, address, graph-
ics or inscriptions) on the envelope up or down.
Adjusting the right horizontal edge moves all right-justified elements to the left or right. These
elements include any item on the left side of the indicia, for example, a graphic ad, inscrip-
tion or text message.
1. Ensure that the appropriate job is open and selected on the Run Mail screen.
2. Select anywhere within envelope on the Run Mail screen. You can also select the Edit
envelope link.
3. Select the Print position option from the list box on the left of the Edit envelope screen.
4. Set the offset value from the top edge of the envelope. The offset range from the top of the
envelope is 0.25 to 0.50 inch (6.4 to 12.7 mm).
a. Select the + or - button once to increase/decrease the value by 0.05 inch (or 1 mm).
b. To continue increasing/decreasing the value hold the + or - button for at least 2 sec-
onds. For each second you hold the button, the value increases/decreases by 0.1
inch (10mm).
85
SV62250 Rev. G