Reactivating Spot Black (#2) Printing - Pitney Bowes Connect+ 1000 Operator's Manual

1. Select Turn off spot black (#2) ink printing when the Out of Ink warning appears.
NOTE: If the "out of spot (#2) ink" warning error appears on the Run Mail screen, select
Turn off spot printing to view the Out of Ink warning.
2. Review the terms and conditions.
a. Select I have read and agree with these conditions.
b. Select Yes, turn black ink printing off.
3. A warning appears indicating that your system needs to be reconfigured to turn off spot
black (#2) printing. Select Yes, proceed.
4. Follow the prompts to remove the ink cartridge and reconfigure the system.
5. Once the system has been reconfigured, you will be prompted to print test patterns on
tape. Select Ready.
6. Select Tape.
7. Check the test pattern.
If the solid lines of the test sample are unbroken, select Image is OK - Done.
l
If the test sample has missing or incomplete lines, select Not OK - Clean print head.
l
Once the cleaning operation completes, you will be prompted to print another test sam-
ple. If the pattern still has broken or missing lines, you may need to replace the ink car-
tridge or print head.
Once the test pattern has been approved, an alert message will appear on the Run Mail
screen indicating that you have 14 days to reactivate spot black (#2) ink. In addition, a similar
warning will appear on the Home screen each time you power up the system.

Reactivating Spot Black (#2) Printing

While the spot black (#2) grace period is active, the status bar on the Run Mail screen will
display an alert with the option to reactivate spot black (#2) printing.
On the Run Mail screen:
1. Select Reactivate Spot K.
2. Select Yes, proceed.
3. Follow the prompts to install the ink cartridge and reconfigure the system.
SV62250 Rev. G
Connect+® Series Operator Guide
206