Printing A Date Correction; Printing A Postage Correction - Pitney Bowes Connect+ 1000 Operator's Manual

Printing a Date Correction

You can print a date correction if you need to modify the date printed on your envelope. If you
have already created a date correction job, open the job and begin running mail.
Follow the steps below to create a date correction job.
1. Select the Options button at the bottom of the Run Mail screen.
2. Select Create new job... and then select Date correction.
3. Select OK. A new job tab appears. The Job Properties list is populated with the required
date correction job settings.
NOTE: The weighing method is not displayed in the postage correction job. Sealing
mode is set to off.
4. If necessary, change the format of the date.
5. If you are printing a tape, select the Tape button.
6. If you are printing on an envelope and if the envelope is sealed, change the sealing
method to sealer off.
a. Turn the piece of mail around 180 degrees so that the postal indicia is in the lower left
corner. Place the envelope on the feed deck with the flap facing down.
b. Select the Start button.
7. To save the job, select the Save As link at the top of the screen.
8. Enter the job name and select OK.

Printing a Postage Correction

If you do not have the correct postage on a piece of mail, you can add more postage by print-
ing a postage correction directly on the envelope or on a tape. If you have already created a
postage correction job for the amount required, open the job and begin running mail.
Follow the steps below to create a postage correction job.
1. Select the Options button at the bottom of the Run Mail screen.
2. Select Create new job... and then select Postage correction.
3. Select OK. A new job tab appears. The Job Properties list is populated with the required
SV62250 Rev. G
Connect+® Series Operator Guide
35