Table 170: Show Mvr6 - Display Description - Edge-Core ECS3510-28T Management Manual

| Multicast Filtering Commands
C 38
HAPTER
MVR for IPv6
show mvr6
This command shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current number of group
addresses, and the upstream source IP address.
S
YNTAX
show mvr6 [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
D S
EFAULT ETTING
Displays configuration settings for all MVR domains.
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
The following shows the MVR6 settings:
Console#show mvr6
MVR6 802.1p Forwarding Priority: Disabled
MVR6 Proxy Switching
MVR6 Robustness Value
MVR6 Proxy Query Interval
MVR6 Source Port Mode
Domain
MVR6 Config Status
MVR6 Running Status
MVR6 Multicast VLAN
MVR6 Current Learned Groups : 0
MVR6 Upstream Source IP
Console#

Table 170: show mvr6 - display description

Field Description
MVR6 802.1p Priority assigned to multicast traffic forwarded into the MVR6 VLAN
Forwarding Priority
MVR6 Proxy Switching Shows if MVR proxy switching is enabled
MVR6 Robustness Shows the number of reports or query messages sent when proxy
Value switching is enabled
MVR6 Proxy Query The interval at which the receiver port sends out general queries
Interval
MVR6 Source Port Shows if the switch only forwards multicast streams which the
Mode source port has dynamically joined or always forwards multicast
streams
MVR6 Domain An independent multicast domain.
MVR6 Config Status Shows if MVR is globally enabled on the switch.
MVR6 Running Status Indicates whether or not all necessary conditions in the MVR
environment are satisfied. (Running status is true as long as MVR
Status is enabled, and the specified MVR VLAN exists, and a source
port with a valid link has been configured (using the
command.)
– 1280 –
: Enabled
: 2
: 125(sec.)
: Always Forward
: 1
: Enabled
: Active
: 1
: FF05::25
mvr6 type