Required Accessories; Using The Product In A Vehicle - Otto Bock Dino 3 Instructions For Use Manual

Use

7.15.1 Required accessories

If the product has been approved for transport in vehicles for transporting persons with reduced mobility, it is
equipped with four eyebolts on the frame (see fig. 48, item 1).
48

7.15.2 Using the product in a vehicle

WARNING
Positioning in vehicles for transporting persons with reduced mobility
Serious injuries in case of accidents due to user error
► Positioning of the product in vehicles for transporting persons with reduced mobility may only be performed
by the qualified personnel.
► The product must always face forwards when it is used as a seat in a vehicle for transporting persons with
reduced mobility.
► Instruct the qualified personnel regarding the mounting points on your product described below.
WARNING
Inadequate transportation safety
Loss of safe restraint due to failure to observe transportation instructions
► Observe the following instructions for correct transport safety in the vehicle for transporting persons with
reduced mobility.
► If necessary, instruct the qualified personnel on the following information.
Securing the product in the vehicle for transporting persons with reduced mobility
The product is attached to the eyebolts (fixation points) using four vehicle side restraint belts.
The fixation points are marked with stickers. The stickers show where the vehicle side restraint belts have to be
engaged.
1) Position the product in the vehicle for transporting persons with reduced mobility. For more information, refer
to section 5 in the brochure "Transporting persons with reduced mobility", order number 646D158.
2) Hook the attachment straps into the lashing points at the front and back and tighten them (see fig. 50, item 1;
see fig. 51, item 1).
Information on correct transport safety of the user in the vehicle for transporting persons with reduced
mobility
• Using the personal restraint system of the vehicle for transporting persons with reduced mobility is required.
The three-point personal restraint system is attached in the vehicle for transporting persons with reduced
mobility as follows:
– The lap belt of the personal restraint system is usually attached by the qualified personnel to the left and
right sides respectively on the mounting point/pin of the product.
– The shoulder harness of the personal restraint system is usually mounted on the vehicle pillar and is
attached by the qualified personnel to the corresponding mounting point/pin provided on the lap belt.
• The straps of the personal restraint system must always be routed close to the user's body. The straps must not
be routed over the side panels and wheels (see fig. 49 item 2).
• The shoulder belt must always be routed over the user's shoulder (see fig. 49, item 1).
• The belt strap must not be twisted on the user's body.
36 Dino 3